I want to sync files and exclude files over a certain size (e.g. 2Gb). File formats are varied (e.g. mp4, csv, ...).
I can't figure out how, with no other filter, just size only.
Any ideas?
Before posting, and to avoid disappointment, please read the following:
- This forum is not for 2BrightSparks to provide technical support. It's primarily for users to help other users. Do not expect 2BrightSparks to answer any question posted to this forum.
- If you find a bug in any of our software, please submit a support ticket. It does not matter if you are using our freeware, a beta version or you haven't yet purchased the software. We want to know about any and all bugs so we can fix them as soon as possible. We usually need more information and details from you to reproduce bugs and that is better done via a support ticket and not this forum.
- If you are entitled to technical support then please submit a support ticket. Please do not post the same question to the forum and also via a support ticket. Once again, 2BrightSparks does not provide technical support via this forum.
v.11 - Filter files by size
-
mmullins_98
- Expert
- Posts: 269
- Joined: Wed Jun 05, 2019 11:40 am
Re: v.11 - Filter files by size
Perhaps the COMPARE OPTIONS (File Size tab) will do it. The "and Ignore files more than" explained below.
Ignore files less than… and ignore files more than...: To ignore files of a certain size, or within a size range, set these options as appropriate. A value of zero is ignored, e.g. you cannot ignore all files over zero bytes in size. Note that the size applies to both files (left/source and right/destination) if they both exist. For example: you want to ignore files less than 10 bytes in size. If there is a source file of 9 bytes and a destination file of 11 bytes then it will not be ignored (as the destination file is over 10 bytes in size). If there is a source file of 9 bytes and a destination file of 9 bytes then it will be ignored. If there is only a source or only destination file then only it must match the size requirements.
Ignore files less than… and ignore files more than...: To ignore files of a certain size, or within a size range, set these options as appropriate. A value of zero is ignored, e.g. you cannot ignore all files over zero bytes in size. Note that the size applies to both files (left/source and right/destination) if they both exist. For example: you want to ignore files less than 10 bytes in size. If there is a source file of 9 bytes and a destination file of 11 bytes then it will not be ignored (as the destination file is over 10 bytes in size). If there is a source file of 9 bytes and a destination file of 9 bytes then it will be ignored. If there is only a source or only destination file then only it must match the size requirements.