Backup to Zip uses a variable called ‘source’ that determines where the data comes from and where it’s stored. For example: if ‘source’ is “data01”, the profile gets the data from
D:\%source% --> D:\data01\
and writes it to:
U:\backups\%source%.zip --> data01.zip
“Backup to Zip” is called by the group profile “Backup to zip – data01” that sets ‘source’ to the correct value and calls “Backup to Zip”.
A master profile called “Back up to external disk” calls all the “Backup to zip – data01”, “Backup to zip – data02”, “Backup to zip – data03”...
In a nutshell, the profiles are:
Code: Select all
Back up to external disk (master profile) Backup to zip - data01 (set source = data01) Backup to Zip Backup to zip - data02 (set source = data02) Backup to Zip Backup to zip - data03 (set source = data02) Backup to Zip
Failed to scan files: Backup to zip (Backup to zip – data01): The profile is already running or is due to run.
I disabled all “Run profiles in parallel” but it makes no difference.
Do you have any suggestion?